| |
Return to List
Too Young to Know | In 1948 my dad bought a new 8N Ford, it came with a pick-up disk. I got on it the minute it was unloaded. Dad wanted to see just what it would do. I was 14 at the time so when I came to the end of the field there was a turn road and a fence. I pulled the power lift and the front wheels came off the ground - I went through the fence into a public road. I hit the left brake and turned around with the front wheels still up in the air. I put another hole in that fence before I could stop it. My dad was more than a little upset. Needless to say with all the scratches on the new tractor he helped me get off by grabbing my arm and throwing me to the ground. Well I didn't get the job of driving that tractor. He assigned me to the irrigation crew. The pipe was laid and this huge pump was backed to the the ditch that was filled with water. By the way this pump was new and had a big Chrysler V/8 with straight exhaust pipes that you could reverse the exhaust and prime the pump. You guessed it - I was told to start the pump and prime it. When it was primed I opened the throttle wide open and when the water hit the end of that pipe all heck broke loose. The pump was pushed backwards and flipped upside down in that ditch full of water. This all happened as my Dad watched from his car. I had to me a job in a store as I was not allowed to touch not even a hammer after that. He always told everyone that I could brake an anvil wirh a rubber hammer. Tom Elenburg, MS, entered 2000-09-17 My Email Address: Not Displayed |
Return to List
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|