| |
Return to List
Plowing Goof | When I was about 14, Dad told me to go next door to the neighbor's and plow his large garden patch for him, and to plow the reverse of what we did last year (dead furrows in the center). I got the 8N, hooked up the 2 bottom Dearborn and headed out to the neighbors. Plowed from outside in as instructed and got'er almost done. Got to the end of about the last run, hit the left brake hard to turn back to finish, and WHAM. Stopped, and the moldboard extension had hit a 6 inch maple sapling as the tractor swung around and snapped that moldboard right in half.....no more plowing that day. We welded up the moldboard and ground it off smooth, but that plow never did work perfectly again until we replaced the moldboard. Needless to say, Dad was NOT happy. That stood as the biggest screwup I had done, at least up until then. BillM (OH), OH, entered 2012-08-17 My Email Address: Not Displayed |
Return to List
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|