| |
Return to List
Hay Sweep | Some years back was talking with a fellow of like years to myself. As a teen he had worked summers for a farmer notorious for keeping equipment in use long past retirement age, like he was himself. The job for the day was to finish pushing the hay windrows together, or running a hay sweep. The guy let him off at the top of a hill, pointing down into the valley, 'the sweeps down there', and left. It was a homebrew haysweep made from a very early Chevy truck, a four cylinder, with the steering and controls backwards on the chassis, as so many hundreds were. Climbing into the seat, he switched it on, and pushed down the starter button, the starter gave a single groan and quit. Clamboring around to the front, he found the crank was still in place, but couldn't swing it due to the iron bracing welded to the frame, at best he could only give it a half turn. So he walks back to the buildings, and found the farmer. 'The battery is dead, couldn't start it'. Driving back to the field, the farmer apologized for not telling him the secret combination. The old guy climbed through the bracing, grabbed the crank, and pulled it up to compression, then moved quickly to the seat, switched on, and jerked the ignition advance lever on the steering column, the engine coughed once and was running! Seems he had been starting it that way for years rather than buy a new battery. The engine was loose enough that all it took was one cylinder to fire. Once it warmed up, he swept the windrows with no further problems. home brew mechanicing! John in Nebraska John, Ne, entered 2002-08-05 My Email Address: Not Displayed |
Return to List
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|