| |
Return to List
Its Mine Now | Seeing the story about the MM-R made me think back to my growing up on a farm in Priddy, Tx. Mills Co. My dad and I, along with my grandfather, farmed several farms in the area, including my grand father's place at Indian Gap, Tx. (250 acres of Pecan bottom on the Cowhouse Creek). Our farm also had the creek running through it. One winter the creek froze over, I thought it was thick enough to hold the tractor. NOT! I dropped the R right in the middle of the crossing, my dad had to bring the 'Massey' down to drag it out. I thought that was the end of it until my father went to start the tractor, not knowing the clutch had siezed due to the water, and the R nose could be seen from the outside of the shed, thru the front wall. (Oh, my goodness). I remember many hours on that tractor and relish all the memories of my childhood on that farm. Even when my dad came home from the field with one pants leg of his overalls missing due to the PTO. A safety lesson, no doubt. My grandfather said he remembered one of his brothers doing the same thing, he did have on stretchy suspender overalls and the PTO wrapped up his pants leg so tight that it shot him off the tractor when it finally tore. My grandfather had a JD-G and rode that thing till he was allmost 90 years old. He had a new gas-saving carb. put on it and it worked so well that he had to stop and drain the tank several times a day. I now have the R (bought it back) and a Farmall A like the one with which we used to dig potatos and pump water water out of the creek. I remember those times well. Donald R. Marwitz, TX, entered 2003-01-01 My Email Address: Not Displayed |
Return to List
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|