| |
Return to List
Grandpas Teaching Lessons | Well when I was 16, my Grandpa told me when I was big enough to start the old JD A I could keep it at my house. well I tried but I had it pop on me and almost rip my arm off. From then on my Grandpa told me to pull and as soon as the wheel took to a full spin to get back and wait for it to stop spinning if not started and then go at her again. After I figured out how to spin her right then I havent had a problem starting the old girl anymore. I sure do love my Grandpa and the 1937 JD A that he has givin me so that I can enjoy her the same way he has over the many years of owning her. also my dads gave me a 1936 Case CC which uses a crack which can snap your arm in a blink of a eye. I learned a lot from my Grandpa and my father and dont plan to let it go to waste so I plan to pass it on to my children some day. hope you enjoyed the story and God bless. Brett, Mi, entered 2003-10-26 My Email Address: Not Displayed |
Return to List
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|