| |
Return to List
Puzzler | Heres a story I heard one day.And wanted to pass on. One day Jim was going to help grandpa Dave saw some boards, with a John deere B belt drivin saw. The same old B that was the first tractor Jim ever drove.When down in the barn to get tools and such,Grandpa tells Jim to grab that six foot bar.Grandpa says its the most important part.Jim asks what its for,no reply from grandpa he just walks up the hill to the old rusty B and gets to work. So Jim lugs the bar up the hill.He carries over to the old rusty B hesitates(ahh whats another scratch).And leans the six foot bar against the beat up old tractor. So they go on working the day away and take a quick break for lunch. While sitting on pops old pickup Jim notices the bar still sitting in the same spot he set it earlier.But he didnt pay too much mind. At the end of the day when Jim and Grandpa Dave were picking up Jim again notices the bar still in the same place not moving an inch. Not wanting to question his wise but old Grandfather. He has to ask why he brought the heavy bar up and never used it. Grandpa says 'Hell boy I thought you knew' and walks away again.Just like when Jim was a little boy,he catches up to Grandpa and pesters him for the answer. Grandpa's answer was simple and made Jim deffinetly feel like that nieve little boy. Well if you run a couple metal machines with a rubber belt,and not one is touchin the ground.You'll find out in a right hurry they got some static charge that'll curl your hair when ya grab hold. Well there's another lesson from Gramps.Thats one that had to learned by experience. CM., ny, entered 2005-03-06 My Email Address: Not Displayed |
Return to List
Home
| Forums
Today's Featured Article -
My Ford Golden Jubilee - by Troy Estes. This article is about my '53 Ford Jubilee and a story that starts with taking the tractor to my brother's Starter/Alternator Rebuilding shop for a wiring fix. The generator was shot as well as all the wiring. I dropped off the tractor expecting a transformation from a 6 volt to a 12 volt system utilizing the original generator housing, and a total rewiring of the whole tractor. The front end center pin bushing was worn also so I ask that they replace it if they had time. Well, that’s wha
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
|