Posted by Grabatire on December 11, 2010 at 11:15:11 from (173.210.180.23):
In Reply to: TD 6 Crawler engine posted by JDS1 on December 11, 2010 at 08:19:53:
I"m sure it just slipped rustyfarmalls mind, but there are a few other things to consider. You will also need to change the mounting plate on the rear of the engine as well as use the flyhweel from the TD6 to facilitate the starter. The oil pan and oil pump on the crawler engines are designed to allow operation an steeper grades than is the MD wheeled tractor, so those should be swapped as well. Also, the crawler engine uses a dipstick to measure the oil level, whereas the Farmall uses petcocks located on the pan which are not accessable if the crawler has a belly pan. There is a spot on the MD engine that can be drilled and tapped to accept the drop tube and dip stick.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.