Posted by Dan in North Houston on December 10, 2010 at 18:08:19 from (210.82.62.229):
In Reply to: posted by Brad Gyde on December 10, 2010 at 17:54:13:
Back in the 70's, before Ford offered a dually, we took a F250 and made it into a dually. We had to get the dual type rims, of course. As I recall, we got some longer studs, a spacer ring, and fiberglass fenders from JC Whitney. It was a brand new truck, and we had the fenders painted to match, so it ended up looking factory. I don't remember if the spacer ring went between the hub and the inside wheel, or between the wheels. Seems to me it was about a half inch thick.
You probably wonder why we went to the trouble, when you could get a Chevy with duals at the time. We had tried the Chevy with the 454, couldn't keep gas in it (4 mpg empty) and the transmissions couldn't stand the heavy hauling for the goose neck trailers we pulled. We wanted the Ford because of the Club Cab and the 390 engine with 4 speed. It worked great, probably the best trailer pulling truck we ever had on the farm.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.