Posted by Don-Wi on November 03, 2010 at 17:07:03 from (75.219.136.26):
I got the ceramic pads for my wife's car, and also a new cap & rotor for my truck (88 F150 w/ 4.9) as they didn't have any more last time I went. Got to talking with the guy behind the counter and he said his brother stripped out a hole on the dist. for one of the screws that hold the cap on. That's when it happened... I asked "How in the heck a guy can do that?
Now my truck is sitting with a screw that BROKE OFF in the distributer. Was planning to use it on Friday to haul 4 tons of pellets but now it looks like I might have to fix this old truck.... Gonna take a look tomorrow to see how hard it is to pull the distributer.
Also- whats the timing? I put the new cap in place just to get a better look at the old one, and I want to make sure I didn't cross any. Gonna scribe a mark before I pull the dist so I hope I can just drop it back in & go once I get that old screw out.
Kinda wishing I left well enough alone until Sunday now, but better to fix in early November than late December right?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.