Posted by NW Ohio Tim on January 26, 2010 at 20:43:14 from (76.76.36.32):
Hey Guys,
I picked these up at an auction last summer.
I don't know if they were made to be three point adaptors but that's what I'm going to use them for.
They measure 27" from the point to the center of the hole. Does anybody know the correct length for a cat 1 adaptor on an IH 330?? It looks a little long when it's on the tractor. I assume it would be the same on all 300 series tractors.
The holes are 1 1/4" diameter, they'll have to be bored out to accept the new ball sockets. I'm taking it to a welding shop in the morning because there won't be much meat left after the hole is drilled.
Thanks for any help.
Tim K in NW Ohio ~ Needing to get this done before it snows and my new old blower needs used.
This post was edited by NW Ohio Tim at 21:36:57 01/26/10.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.