Posted by Leroy on December 13, 2009 at 07:35:08 from (209.143.52.233):
In Reply to: Strength of pipe?? posted by dave2 on December 13, 2009 at 05:09:32:
That 4' x 6' box with those pieces running the long way of the box would give you only 3' sticking out over the axle each way and I dought very much that you could load it that heavy with manure on 2 pipes that you would have any problems. What would be good is for to put one down the middle for you to put the dump latch on to fasten to the toung. On each end of the center piece put a tee there with a 2' piece to each side with an elbow to fasten to each side piece and you will have a solid bed frame. Now if you were going to have 6' to each end of the trailer from the axle like I think most posters are thinking of then yes you would need several pieces to get any strength but for 3' out no problems at all with strength. And fot tipping the trailer just mount a small jack between the toung and bed. I have seen 18' tandam axle trailers that were factory built that used a modified 2 ton floor jack for the tipping. If there over there in Germany are small sizer jacks with a crank handle to raise and lower your car to change a tire one of those would work good fore tipping that trailer. The higher the bed the easier it will be to tip to unload.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.