Posted by TimMiller on November 03, 2009 at 09:44:49 from (70.242.1.46):
In Reply to: Installing duct work posted by TimMiller on November 01, 2009 at 21:10:21:
Personally if it were me, i'd get someone to do it, but they dont. I know all of the insulation values, and no ductwork will be exposed to the sun. We are planning to use flex ducts. I do have the whole other side of the house to use as a guide, since it was all installed by a pro. One idea I had was I will try to figure it out as best as possible, put it on paper, then he can run it by one of his HVAC guys, or I can mention the possibility of him just giving the guy some $$$ to design it. I can draw up a rough blue print of everything, with the insulation values. Over the entire roof (up stairs is a vaulted ceiling) it is R-13, between the walls it will be R-30 along with the ceiling. Her mom wants EVERYTHING insulated, including the closets. She also wants ducts run to the closets, to just provide a little air to "keep moisture down."
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.