John T Probably not much help, but here goes. Drove bus about 8 years, with some shop experience. Working from memory here,only drove one 4104. 4104 should be a rear engine, right? Does the engine sit crosswise, with an angle drive between clutch & trans? Does the trans sit kittywampus? Or does the engine sit inline, just backwards in the 4104? Thinking because of length, engine sits inline. 8V engine sits crosswise in 47xx models. Is it an oil-bath clutch? Not sure on the 6 bangers, but 8V models had oil bath. They would rattle, bang, & shake the whole rig when first put in gear. Considered to be normal. Be sure the fast idle is off before trying to shift into gear. They had high speed diff gears, oil clutch allowed lots of slippage to get moving. Guess I'm not much help after all. To really confuse things, if the engine sits crosswise, it spins backwards too. Sorry for getting off track. Willie
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.