Tractor Talk Discussion Board |
How to Pull Safely?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by David A on November 21, 2000 at 07:35:44 from (208.237.135.21):
As a part time tractor operator around my property I am very interested in safety. How can I set up my Super A to pull stuff like skidding logs out of the woods and be assured it cannot wheelie flip? I'd like to know it will just stall out or spin wheels if the load is too much. I know that pulling from a point below the axle (drawbar) is best. I've also heard a long drawbar extending backward helps because the lever action works against a rising front. At tractor pulls I've seen the front rise about a foot or so and seemingly reach equilibrium with no real concern by the operator. Could someone explain the mechanics of all this to me to help me make a safer setup?
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|