Posted by super99 on May 17, 2009 at 04:20:33 from (75.107.181.15):
Exhaust pipe on my Dakota pickup rusted off where it had been welded together. I need a connector that is 2 1/4 to 2 3/8 to repair it. Only ones I can find are 2 1/4 to 2 1/2. So I bought a exhaust tube expander at Farm & Fleet and a piece of 2 1/4 in exhaust pipe. I put it in the pipe vise and tightened it up until it won't move with a impact wrench and it barely moved it at all. I have used a different type of expander before and got along alright. Is this tool junk or am I going about it all wrong? It's supposed to work from 1 1/2 to 2 7/8 pipe. When you tighten it up, the small end expands and the large end doesn't hardly move. If I heat the pipe first, it will probably melt the o-rings that hold it together before it does any thing else. I wondered about cutting slots in the pipe, but it wouldn't be round. Any suggestions, or do I need to get a better tool? Chris
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.