Posted by patsdeere on March 01, 2009 at 09:26:19 from (24.4.17.197):
In Reply to: SandBlasting posted by 2510Paul on March 01, 2009 at 08:48:34:
I usually take all the big stuff (sheet metal, large castings) to a pro, and do the small stuff inside a small harbor freight blaster at home. The bigger compressor the better (plus some way of catching/sucking the dust out of the cabinet if working at home). I use aluminum oxide and it works pretty good. Doesn't always slide down the bottom of the unit real well, but that just tells me it is getting dirty/wet. If blasting outside with a pot make sure you have some type of mask on with a very fine filter. It won't stop everything, but it will reduce what you breathe in.
1 think I always forget, this old paint has lead and isn't the greatest to breathe.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.