Posted by Rocco on December 29, 2008 at 17:47:53 from (121.146.87.131):
We have two old IH's a 300U and a 350U both gasoline engines.
Problem with the 350U Two years back an unnoticed tree stump knocked a hole in the oil pan, and now the rod/crank bearings are shot. Can you folks point me in the proper direction to find oversize crank/rod bearings and a gasket set for this motor?
Problem with the 300U This old beast always has some problem... lately the hydrolic fluid has been coming up low, now she leaks a drip or two but not enough to displace this much fluid (loses maybe a gallon a week). The engine has also been blowing a LOT of oil out the overflow vent, but when we check the oil lever is always ok (usually showing a bit too full, but not milky as in water).... I am thinking some seal or gasket has gone and is allowing the hydrolic fluid to leak into the engine case... is this possible?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.