What you probably have is glazed tile, real popular in our area. I would guess I could find some for you. They vary in size as they were extruded, and cut with a wire. You can see sometimes where the block are bent down on the ends where the wire cut the hard clay dirt.
We make them at the (antique show)Plagman barn / NEIFAA near Garber Iowa. We however do not fire the block as we never get enough help. We don't even have a kiln and probably never will. The last few years we have been to short of help to make block.
We used to fix alot of buildings & silos, but not so much anymore. We always paint the tile surface with mason cement and water in a laytex paint consistancy. If you have a drywall testure gun, it will only take a couple of munites to spray it on all surfaces. This mortar paint gives you a real rich mix at contact point. Best I can guess is to throw the mud into the cavity with a laytex gloved hand, it will stay where put once you get on to it. Then you may want to stucko the whole busted surface inside and out.
Manure on these tile can make them very unpredictable if you ever tear it down. The tile silos will sometimes crumble once they start to fall like a tree.
If you choose to buy the premixed mortar mix, be sure to add mason powder to richen up the mix because you are buying mostly sand with a sprinkle of mason cement.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.