Posted by Richard R. Heysek on October 22, 2008 at 11:31:00 from (75.218.85.10):
I have been kicking around the idea of rebuilding my present trip loader on my Ford 3000 to turn it into a real loader with a tilt bucket and down pressure. It is very stout construction wise and it has a very heavy frame all around. It is made by Ford and if I were to convert it to a real loader assembly, it would be quite a nice unit to have here on the farm. I have been looking around at complete replacements but they are pretty pricey, and since I have a good amount to start with I think it could be done cheaper, rebuilding the present loaer.I know the pump, valving, and lines are all considerations to think into the finished cost. The bucket was shot anyway so that is a wash. Can any of you fabrication guys chime in and tell me if I am on to something, or am I just nuts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.