Posted by moonlite 37 on August 22, 2008 at 18:42:31 from (204.8.188.142):
I have not heard much pro's and con's on increased bore kits. I have had mixed results. In 1950's we had a WC Allis with 4 1/8 LP pistons. we used regular gas but would like to have had Ethel.Was a great runner but hard to start. Would pull 2 14's in third. Engine should run about 1350 I ran mine 1700 RPM until it threw governor weights. I have an M farmall with 4 inch and it is a great runner but when I worked for Ford and later for AC they frowned on increased bore kits. I put standard new old stock in ny H farmall and I do not expect or get much performance from it but I like it. My opimion is with larger tractors cheap there is no need to go bigger unless you are into competetive pulling. Let's hear it from all!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.