Posted by Don-Wi on December 04, 2007 at 11:42:23 from (70.224.212.4):
I am looking at buying an old truck mounted plow to put on one of the tractors. I'm just debating how I want to mount it.
Ideally, I could mount it to the loader and keep the hydraulic angle (would need a 3rd set of remotes) so then I could have the angle and down preasure, and be able to push it up higher.
Otherwise I was thinking about mounting it to the front of one of our tractors (probably my 1600) so I could use the hydraulic angle yet, but I wouldn't have any down preasure for back dragging, and I wouldn't be able to push it up as high.
My other thoughts are to make up a set of cylinder stops that I could mount on the loader so I would be able to disconnect the tilt cyliners, and then run some lines to run the angle.
Best part about the 165 is that it has a weather break on it and it actually throws good heat, so it'd be warmer than some of my other options.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.