I did soak the value guides and rings and got the engine loose, but bent a few push rods in the process. I have replaced those, but the engine compression is very low 50 to 65 pounds per cylinder. I am going to try the 12 volt battery with starter as it sounds the simplest. If that fails I’ll still need a little more help because of my lack of knowledge of the hydraulic system. I can place a jack or 2 under the bucket or use an engine hoist above the bucket to try and raise it. My concern is the hydraulics will still prevent it from moving. Do I just need to pull back on the control levers once upward pressure is applied to the bucket and arms to allow the flow of hydraulic fluid in to the lift cylinders? I thought about disconnecting the hydraulic lines to the cylinders and jacking it up before, but my concern was opening the hydraulic system to air. Introducing air into the system was also a reason for not trying to add an alternative hydraulic source. Thanks, Ray
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.