If you figure the cost of a 1 wire alternator, a battery, and then the time to fab a bracket I suspect you'd have $75 - $100 in parts unless you just happen to have this stuff around from another project. Thats not considering replacement of bulbs for your lights.
If your going to keep the "original" look your probably going to spend much more converting everything over unless you need a generator overhaul anyway. The voltage regulator will set you back $45 to $60. I'm not sure what the conversion from 6v - 12v is for a generator. Then you still have the battery cost. Lets estimate $150 to keep the original look, but it's probably more.
Now, if you want to go to 12v, because you can"t stand the "unreliable" or slow cranking nature of things when trying to start the tractor your problem can probably be solved without making the conversion.
REPLACE all 3 of your battery / starter cables with 00 or 1 guage. Anything smaller and you will not get the current necessary to make things spin fast.
I just redid my Farmall H, the cables cost between $15 and $20, depending on the length. My generator was still good (brushes ok etc) and I replaced my voltage regulator ($46 at TSC) as I was not showing a charge. I rewired the tractor and put in 3 new lamps while I was at it since I was dong everything else.
I have approx $120 in refabricating / repairing the entire electrical system. My H cranks and starts just as good as if I had a 12v system. I didn't have to hack my hood or fabricate anything to make it work.
I suppose it's all relative to what you want to spend... I think it will cost atleast that to convert to 12v from scratch. Other than a "personal preference" I see no reason myself.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.