Tractor Talk Discussion Board |
Ford 2000 Injector Pump Timing
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Jack3424 on August 11, 2007 at 03:02:28 from (68.240.241.156):
The manuel says to line up the scribe marks in the observation window. They will not line up, I cannot turn the pump far enough. I have tried to move the drive gear back a tooth, but its to far the other way. The scribe mark on the cam is not in the center, its off to the left side, it was recently rebuilt. The tractor runs but not very good, I know it has other problems (wore out) but I feel like I need to make sure the timing is right before I tear the engine down. the reason he had the pump rebuilt was oil pan was getting deisel in it. The injector pump is a Roosa Master B9NN-9A543-A. Any ideas or help would be appreciated. I also bought the tractor for 1000, did I get hosed?
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|