Tractor Talk Discussion Board |
Re: Wheel bearings
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by David in Md on August 02, 2007 at 08:54:24 from (199.145.20.248):
In Reply to: Wheel bearings posted by 550Doug on August 01, 2007 at 06:43:16:
I just finished 30 sets including the wheels and coulters of my no-till drill. In most cases the inside bearing failed first because moisture and dirt got past the seal. I bought a $24 Lisle bearing packer which is a container which holds grease under a piston. As you push down on the bearing with a handle it forces grease uniformly up through the bearing. I"ve also seen $7-8 versions that use a grease gun to force grease through the bearing. I tried to find the old fashioned sticky wheel bearing grease I used to use but apparantly it is no longer made. A reputable auto parts store recommended the Castrol blue grease as the best currently available. One final thing I did was to drill and tap each hub for a grease fitting so I can push grease through the bearings and out to the seal periodically.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|