Tractor Talk Discussion Board |
Re: Briggs old style recoil clutch problems
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by Wayne Swenson on February 18, 2007 at 19:22:07 from (71.13.41.243):
In Reply to: Briggs old style recoil clutch problems posted by Mike from cny on February 18, 2007 at 16:41:25:
As a Small Engines instructor for 30+ years, I have fixed many of the "squealing, rope spitting" recoils on B & S engines. Remove the square(very old machine) or newer rounded clutch drive. Locate & clean all the ball bearings. Clean all residue out of the cup/flywheel nut. Many times I needed to file the long end of the crankshaft back to a round shape where someone hit it with a hammer while attempting to remove the flywheel. Lightly lube the end of the crank and put a drop or 2 of engine oil inside the clutch drive; place the drive on the crankshaft, replace the ball bearings, install the retaining parts and you are good to go.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|