Tractor Talk Discussion Board |
Re: Question for Allan on 66 series
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by trw on January 14, 2007 at 17:52:35 from (69.77.252.16):
In Reply to: Re: Question for Allan on 66 series posted by old fashioned farmer on January 14, 2007 at 12:30:02:
Looks exactly like the one that I am working on, except that I have the rear apart. I got the engine running last winter, and now I am replacing the seals in the rearend and getting it cleaned up. How serious do you get when you are getting the "cast" pieces,(i.e. torque tube, transmission/rearend housing, etc.), ready to paint? I can't get any of this down to bare metal with a wire brush on a grinder, but I can get all the rust and loose paint off. Is this going to be good enough to get a decent paint job?
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|