Tractor Talk Discussion Board |
Re: Window motor magnet is broke
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by NC Wayne on September 22, 2006 at 22:45:38 from (64.12.116.74):
In Reply to: Window motor magnet is broke posted by 1992 F250 window on September 22, 2006 at 14:16:12:
If the magnet is actually broke and not just broke loose then your only choice is gonna be to buy a new motor. Once the magnet breaks it's sorta like a mirror. When a mirror breaks each part becomes a completely different mirror and the same goes for the magnet, (if it's like all the others I've ever seen) each part becomes it's own complete magnet with N and S poles and there's no putting it back together. I just replaced the complete regulator assembly in my own F150 and it's not something I'd want to do several times to get right. Especially since you have to drill out the rivets holding everything and then need the big rivet gun (borrowed in my case) to put the new ones back in. One tip:and you may already know it since you already have the old motor out, but to remove the old rivets take a small diameter punch and drive the pull pin on through leaving a open hole in the center. Once you do this it's really easy to drill the rivets out. Good luck.
Replies:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|