Tractor Talk Discussion Board |
Re: TRACTOR PULL
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by mjbrown on September 04, 2006 at 13:16:30 from (64.179.15.239):
In Reply to: TRACTOR PULL posted by lenray on September 04, 2006 at 11:53:52:
Was this a transfer sled or dead weight sled? I've done both once or twice without all the weight bars etc with a JD720D and 730D. The dead weight sled was timed over 100' distance from a dead stop, chains tight. In that event on a relatively dry track but with a soft spot near the finish the two cylinders did very well as did the Minnie Moes. They seemed to lug it through the soft spot at the end of the track better. In the event with a weight transfer sled on a soft track the Farmalls ruled. I think they had better traction. I know I ran out of grip long before I ran out of power. In that event we had to run in low gear. I think if I could have run in second I would have gone farther than I did. It was still a fun day, not very serious pulling.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|