Tractor Talk Discussion Board |
Re: Long Model 1199-A 3pt hitch backhoe
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by geok on August 17, 2006 at 17:01:23 from (24.249.1.6):
In Reply to: Long Model 1199-A 3pt hitch backhoe posted by William Donnell on August 17, 2006 at 06:11:34:
Your ford 2000 will have plenty of psi to run the hoe. It just won't have the volume. Most any pto pump that puts out 12 gpm or more will do. Most Long back hoe usually have a frame reservoir for your hyd oil. I have seen some older units that did not however. It will be important to install a pick up screen and a filter when connecting a pump to the unit. You may want to consider mounting the hoe on a sub frame rather than on the 3 point. They can be a bit much for a Ford 2000.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|