Tractor Talk Discussion Board |
Re: What tractor would power 52in circular sawmill
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by snitkawl on March 07, 2006 at 14:48:10 from (207.119.124.1):
In Reply to: What tractor would power 52in circular sawmill PTO posted by thefeltzes on March 07, 2006 at 09:12:11:
I think you would be way underpowered with 70hp. I was running a 250hp cummins and pulled that dead a few times. I bought used truck engines and used a TwinDisk clutch setup to build my own powerplants. I have seen them built using the truck transmission and clutch. Another thing you would need is a demand governor. I tried running without that and it did not work. If you should decide to try what Leland suggested(350 car engine)you will have to install a governor on that too. As to fuel effiency, I could run all day on 10 gal. of diesel. The speed of your saw depends on how it is tensioned. Most are set up to run around 550 to 600 rpm. It should be stamped on the saw.
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|