Tractor Talk Discussion Board |
Re: Need Some Advice on I Beam Support for Hoist.
[ Expand ] [ View Replies ] [ Add a Reply ] [ Return to Forum ]
Posted by txgrn on February 17, 2006 at 14:06:47 from (12.39.110.35):
In Reply to: Need Some Advice on I Beam Support for Hoist. posted by TomNTexas on February 16, 2006 at 04:34:34:
Hi Tom, Texas Buddy. 40' is too long. I have the engineering facts to bore you with if you prefer, but dude you are digging a hole you don't want to enter. Best bet is to get a small portable thing like an engine remover or an A frame like (not necessarily) a child's swing platform to do what you want to do. If you must, the beam needs to be aluminum to reduce the weight of the sucker over that span; but have you ever seen a gantry (which is what you are talking about) crane made from aluminum? No. Want more, ask, Mark
Replies:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|