Tractor Talk Discussion Board |
Re: Garret Turbo
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rod F. on April 28, 2005 at 19:31:28 from (142.177.80.3):
In Reply to: Garret Turbo posted by Hurst on April 28, 2005 at 13:20:22:
I doubt that you will find a lot of difference in the prices of turbo's. They're all expensive. Garrett/AiResearch is as good as any turbo. They are now a division of Honeywell, so you might want to check out their website for some model information and distributers, etc. For some reason, that model # (TA31) strikes a chord with me. It seems that it might be a twin inlet turbo. Twin inlet turbo's are know as pulse turbo's, as they tend to provide slight pressure surges, and cam profiles generally allow for a certain amount of scavenging. The exhaust manifold flows are divided in two, and half is fed to each side of the turbo. This was the predominant system on Ford BSD engines. Where you are simply boosting up the engine you have, and not changing the cam profile, you would want to go with a single inlet turbo. Again, I'm not sure on that model #, but check it out to be sure. As stated in the other post, it would be a good idea to speak with an injection and turbo shop. They could also be invaluable in providing advice on turbo sizing, injector nozzel sizing, and pump settings so that you make the power you want without going too far or wasting fuel. You want to make sure that the air/fuel ratios don't get out of whack. A good shop will tell you which nozzels will go with what turbo and the power that can be expected. Good luck. Rod
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|