Tractor Talk Discussion Board |
hydraulic cylinders
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by stu on June 15, 2004 at 08:01:21 from (192.219.124.127):
(New to hydraulics) I have a princess auto 20' implement cylinder. It has a clevis end on teh ram. With no oil or plugs, just bare full of air, I can spin the clevis a bit by hand at the same time of pulling and pushing it in. 'rotate it'. Will this be possible once its plumbed and pressured? I would like it to be able to rotate a bit because it is going onto a small dozer attachment in the center of the blade to push snow and I want to be able to angle my dozer. Right now, the dozer is straight. If I fab in a angle, it will require teh ram of the cylinder to rotate a bit. Make sense? Thank you in advance.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|