Tractor Talk Discussion Board |
Re: ih 756
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Big Jim on April 12, 2004 at 10:17:01 from (199.141.125.33):
In Reply to: ih 756 posted by mike mattingly on April 12, 2004 at 09:01:32:
Mike, There are several possible causes for water in the oil. Warped or cracked head, blown head gasket, cracked block or leaking sleeve o-rings or a cracked sleeve. First of all, I am assuming that you removed the head and took it to a machine to be magnafluxed for cracks as well as the usual valvejob. Second, did you remove the oil pan and pump up the radiator with a pressure tester to check the wet sleeve O-rings for leaks? Third, You said the block isn't cracked. How do you know that? Did you remove the block and take in to a machine shop to be magnafluxed? The problem is often cracks are hairline that can't be seen when the block is cold. When you run the tractor and the block warms up, the crack expands and there goes the antifreeze into the crankcase. Good luck. Hope this helps.
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|