Tractor Talk Discussion Board |
Re: Ford 860 lift problem
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Wayne on December 09, 2003 at 13:37:21 from (192.85.47.1):
In Reply to: Ford 860 lift problem posted by Dave H on December 09, 2003 at 03:21:10:
I had similar symptoms on a 1963 Ford 4000. I pulled the lift cover discovered that the pin that follows the cam on the rocker shaft was worn almost in half. I was able to press the old pin out and went to the NH dealer and found that replacement pin for the 800s & 4000s was no longer in stock however a pin for an 8n was still stocked. I pressed the new 8n pin in, made the adjustments in the IT manual (the ones for those of us that don't have the NUDAY tools) and the lift works fine. Total for parts was under $10.00 and about 1 hour actual labor finding the pin made the project last about a week. After I finished my repair I found a kit listed in the Ford forum from a gentleman named Zane for $40.00 that includes the pin, adjustment gauges and instructions. If you post over on the Ford forum or do a search for "Zane" you will find the info, that would be the way I would go if doing it again.
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|