Tractor Talk Discussion Board |
Re: Re: Where to Mount Lights for Loader Work?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tim on September 21, 2003 at 14:03:59 from (66.218.9.148):
In Reply to: Re: Where to Mount Lights for Loader Work? posted by RAB on September 21, 2003 at 06:07:48:
Good point on not to drill any holes in the R.O.P.S. Someone did weld a bracket up on the middle of the cross bar so I think that they might have had a light up there at some point.And there was black elec. tape on down the side of the r.o.p.s. I was looking over the tractor again today and I might change my mind and put a pair up near the front of the hood,but on the loader brace on each side.I bought a cheap pair of rubber lights today that have a trapazoid beam.I will have to weld a small bracket on each brace but not a big deal.I think being out front like that they should work fairly good. As one fellow pointed out there isn't any real good place to put lights on with a loader.I may run a couple of wires just temporary and try out a couple of different places that might be the best way to go.Thanks to all for your comments I appreciate it. Tim
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|