Tractor Talk Discussion Board |
homemade roller questions
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Lynn Kasdorf- Leesburg, VA on May 22, 2003 at 07:48:45 from (64.236.188.160):
I have a need for a roller to even out my driveway. It is a low lying area that recently got flooded. I got 20 tons of gravel brought in, but now I need to level and compact it. When i walk on the gravel, it is still quite soupy feeling and uneven. So, I was thinking I should be able to whip up a roller to pull behind my Ford 650 tractor. I have plenty of steel scrap, and I figure all i need is a good 55 gal drum with both ends intact, and no holes. I'm thinking that I would run a pipe up the center of the drum for an axle to pass through. I'd weld the pipe to the ends of the drum. I'll need a drum with a removable filler cap, so I can fill with water (and calcium chloride I guess, to prevent rusting?). I'd fashion a yoke out of box tubing and arrange to just pull it from a drawbar. I wonder if it would make sense to fashion a 3pt hitch mounting so that it could be lifted and transported? This would make it easier to manipulate, especially when backing up. Is this ever done? Hmm.. Any particular suggestions? I need to locate a good drum first. I'll haunt all the local industrial areas I can find, but any suggestions as to what kind of place woudl have a good type of drum? I guess an oil drum woudl be the thing to get. What other substances come in drums?
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|