Tractor Talk Discussion Board |
Hydraulic problem - 3 pt. backhoe
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Bill Oakes on May 04, 2002 at 09:44:43 from (12.89.9.7):
I have a 3 pt hitch backhoe on the back of my Ford 1970 4000SU. I got all of the mechanical mounting stuff done fine so it is nice and solid back there. The hydraulic hoses plug into quick connects fed with a single spool valve under the seat. I put the valve in the up position and it feed fluid to the backhoe. The out riggers, boom and bucket move around fine until I put a load on it and then the valve pops to the neutral position. There is a inline pressure requlator on the supply hose. By backing off on the regulator I can keep the valve from poping off but there's not enough pressure to do any real work. Am I doing something wrong or do I have an equipment problem? Thanks, in advance, to anyone that will try to straighten me out. Bill
Follow Ups:
Home
| Forums
Today's Featured Article -
Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|