Tractor Talk Discussion Board |
Help needed, cracked engine block
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom on April 23, 2002 at 22:23:46 from (194.112.145.176):
Hi, Iīve got a few questions: Iīve the chance to buy a ī56 FMD, the problem is that the engine block has been welded, the owner says it was done in 1976 was used until 2000 without any problems. Could a welded block be a problem? "How white" does the thing smoke if it burns water? I started it and ran it for about five or ten minutes and couldnīt recognize a white smoke, only black/blue. But perhaps its difficult to see the white smoke? Could i see the water in the motor oil on the dipstick, or do a have to drain the oil? The engine runs really well, never seen a fmd that runs so smooth and starts easily. How else could i find out, if there still is a crack on the inside of the block? Thanx for your help regards Tom
Follow Ups:
Home
| Forums
Today's Featured Article -
Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|