Posted by RedMF40 on February 21, 2021 at 18:39:07 from (172.58.187.131):
I'd posted about having only half-throttle on my Mac, something stuck.
Finally got down to my shop, took the handle assembly off but the two screws holding the two plastic halves together aren't going anywhere. They are stuck fast. Getting lug nuts off a forty-year weed tractor would be easier because there'd be something to grab onto. These two little screws are dainty things, far recessed in the handle and maybe even brass. Once the heads are mangled, it's game over. Putting everything I have into it, I can only back them off a little fraction of a bit and I've already slipped once and maybe I get two more accidents like that before the head is destroyed.
They're soaking in some PB Blaster now, might have to set this aside for awhile. A shame because it's a good-running saw with lots of power but I'm starting to understand the comments about how much of a pain these are to work on.
That's where things stand now. I have other saws, probably time to get re-acquainted.
Upload one or more videos to your post. Photo and video filesizes should be less than 8MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.