Posted by BadBoi on July 25, 2018 at 14:33:26 from (172.56.11.166):
So I Replaced my center Diff. housing and Diff, pressed new Differential carrier Bearing cones on Differential with matched Races pressed in Axle housings, Pressed new bearings on the Axle shafts with matching races pressed into the bearing carriers, and installed all related seals & Axle gaskets etc. Ready to start installing axles and shims and looking for any Tricks to figuring out shim placement/thickness minus the use of dial indicators, depth gauges,etc..I know there is a lot of different theories out there such as no shims between bearing carrier & backing plates on both Axles to start, 1 shim on left to start-No shims on rt,start with 1 shim on rt, NO shims between the axle housing and backing plates, etc etc etc..IT's manual info of 1 shim between backing plate and housing an 2 shims between bearing carrier/backing plates (even tho they dont tell you shim thickness). :wink: Would like to get it close without having to pull axles,hubs etc apart any more than I have to! :roll: :lol: What's your Method and Starting point :?: :idea: All opinions appreciated :!: Thanks 8)
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.