Posted by RBoots on August 06, 2017 at 11:43:54 from (70.194.27.164):
Hello everyone, I have a neighbor that is building a firewood processor, and is using this pump on it powered by a 371 Detroit. Anyway, this pump and engine combo came off an old bucket wheel trencher/tile machine that is probably 2 or 3 times as old as me. From looking at it, it looks like a 2 section gear pump. Or, is it just a huge 2 stage pump like on a log splitter?? He was asking me if it's adjustable for pressure, and I said I had no idea about it if it's a 2 stage type pump, but if it's just a 2 stack pump, the valve controls the pressure, as I didn't see any sort of relief on the pump. He currently has the smaller portion just looped together. It is running a 6 or 8 inch cylinder, and says it is running incredibly slow, and wondered if it could be sped up. That's why I'm wondering if it is a 2 stage pump possibly. I didnt have a lot of time to look it or his plumbing over to see how it was set up. I told him I had a place I could ask where someone might know. Thanks guys
By the way, I told him he ought not to use iron pipe for hyd pressure if it ends up being over 750 pounds or so.... he's an older fellow and "been using it for hyd line forever" lol.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.