Posted by Lanse on February 23, 2017 at 15:54:19 from (99.190.213.134):
First off I'd like to thank everybody whose so generously helping me get these lights going! I messed around with it for an hour or so and discovered a few things:
-Truck (1984 Ford F700) appears to only have one fuse box, couldn't find a second under the hood as some suggested -There are no obvious shorts - I've wiggled all the wires around for the lights and dont see anything new, this also didnt "adjust" their placement enough to "break" the short's connection -There is no obvious "dangling" wiring, although I did find and remove a bunch I hadnt noticed before. This also changed nothing. -The fuses concerning the lights are ALL working (multimeter indicates connectivity between their ports)
And the main discovery - is that the (aluminum) fuse gets HOT in that fuse box! It'll literally burn you if its been in there for a few mins. Also, it's started (or I've started to notice) that it arcs/sparks as its connected.
What the heck now? I've never had to diagnose/fix something quite like this before. I dont think its a grounding issue, as I replaced most/all the grounds back there when I installed the new lights, and as mentioned - they *were* working just fine... On a side note, when I wired this thing, I wired in the turn signals/tail lights/brake lights all to share a single lamp, per side - as it was when I bought it. Not sure if that'll change anything, however...
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.