Couple quick clarifications--the A5 serial number is typically found on the right side of the receiver, below the bolt release. This is indeed the number you're using, correct? Second, have you looked through the article I linked on Sweet 16 serial numbers. NOT the list on Browning's site? Specifically, there are several other clues there that might help with relative age, such as the country of origin, the address given, the type of trademark used, whether some parts (the trigger and/or safety, for instance) are gold-plated, whether "sweet sixteen" is written in script on the receiver, and several others. As Dodgeit mentioned, while all Sweet 16's are Auto-5's, not all Auto-5's are sweet 16's, though because of their collectibility there's plenty of people who, accidentally or otherwise, will tell you a gun is a Sweet 16 when it isn't. Read through the article and get back to us, but bear in mind this is a VERY jumbled area, where often not even the experts (and I'll freely admit to NOT being one--I know a bit and have some decent sources but there's just too much info out there for anyone to know it all) can always agree--for instance, the article notes that Browning's own long-time historian felt that some of the early guns were indeed "sweet 16's" based on Browning's use of the word in their marketing when the guns were not in fact marked as "sweet 16's", which is usually taken to be their defining characteristic. Also, any gun with a production run of nearly a century, made at several different manufacturing sites, through two world wars (especially important as Belgium was one of the manufacturing sites) and by several different companies, is bound to have differences and discrepancies in its numbering production documentation.
Upload one or more videos to your post. Photo filesizes should be less than 300K and Videos, less than 2MB. Formats allowed are gif, jpg, png, ogg, mp4, mov, and avi. Be sure to use filenames without spaces or special characters, and filetypes of 3 digits lower case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.