If Bubba only connects the genny ground and not the neutral to the welder plug ground, yeah, the 120 can get really wonky, especially if he's actually pulling 240 off the generator. It can also get wonky if the system ground/neutral tie point is a significant distance from the welder plug.
Knew one guy (a Bubba wannabe) who killed the compressor in his fridge because he hooked the genny Hot wire to one leg of his welder outlet, and Neutral to the other from a cut off extension cord, splitting a floating 120 between both phases. At least he properly connected the ground... O_o I'm guessing the fridge was trying to run on about 80 volts. I had to explain why the lights were going from not quite bright to dim as it tried to cycle.
Scott, to verify what buickanddeere said, yes a 4 wire (twistlock) plug and cord from the generator takes care of both providing a proper isolated neutral and bonding the generator frame to system ground.
A local electrical supply house has a Clint Eastwood quote on the wall behind the counter that is very apt, in a font size that can not be missed: "A man has to know his limitations." Unfortunately, the ones who should heed it most, don't get it.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.