Posted by hillbilly2 on April 16, 2016 at 19:49:56 from (70.194.14.115):
Today I started up the Ford 2610 diesel to warm it up to change the oil. I pulled it in front of barn and thought I set the parking brake. Then I did the same with riding lawnmower. I went in the barn and moved a few things around and then noticed I could only hear the lawnmower running.
I looked outside and the Ford took a nose dive into the pond while running at about 1200 rpm. The water was about 4 ft deep in that area but it was enough to suck water in and kill the engine.
I pulled it out right away and put it in the barn and started tearing the engine down to pull the head and pan off because I could see it had blown the head gasket out when it sucked the water in.
One I got the head off I moved each piston to TDC and used a straight edge and feeler guage to measure height from deck to piston. #1 and #3 are both the same (about .008) and #2 is about 45 thousandths lower.
I would assume that means it has a bent rod. It still turns over fine, but I am wondering if it would be safe to run it that way or did it weaken rod and lower compression too much?
Sorry no pics. I had it out of the water in less than 5 minutes and knew it wasn't going to be a moment I wanted to remember.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.