Posted by wilson ind on August 18, 2014 at 17:17:10 from (162.235.98.33):
Two cylinder wisconsin engines need a govenor spring which is no longer available. I have posted on garden and stationary sites, however there is little activity on those sites. Forgive me for posting in tractor talk. Anyone havinc surplus two cylinder wisconsin carburator control rods springs and other linkage, and air cleaner please contact. e mail open I also have pictures of well something I purchased two years ago at sale of decesed fellow. As you can see its jeep cut down axels with a 90 transmission. The tag on the transmission has a rebuild tag dating 1958. I am undecided as to leaving the transmission in ,going to hydraulic motor on each axel.Also going dirrect connection to the engine to hyd pump. Ok folks your ideas????? Of course it needs total revamping, cannot fault the origional builder as he died during the experimental stage of this whatever it is. Tried to find if the jeep transmission had any value but did not find a good site wanting vintage jeep parts,
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Harvestin Hay: The Early Years (Part 2) - by Pat Browning. The summer of 1950 was the start of a new era in farming for our family. I was thirteen, and Kathy (my oldest sister) was seven. At this age, I believed tractor farming was the only way, hot stuff -- and given a chance I probably would have used the tractor, Dad's first, a 1936 Model "A" John Deere, to go bring in the cows! And I think Dad was ready for some automation too. And so it was that we acquired a good, used J. I. Case, wire tie hay baler. In addition to a person to drive th
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.