Posted by oj on August 03, 2014 at 09:32:52 from (199.195.160.196):
I was baling hay a couple of days ago when my gearbox oil pressure light flashed at me (never seen it on except for startup), anyway, got out to investigate, and oil is pouring out of the rear end, from above the hitch area... Shut everything down, and once the oil was all out i could see a chunk of cast approx 1 inch square sitting on the drawbar hitch frame, sure enough there is a hole in the base of the casting (on the mid line). I'm not certain for sure (not got it home and tore apart yet) but i figure something (a bearing maybe) has let go and the pto gears have grabbed it and forced it into the casting, braking a chunk off.
Anybody had any luck welding the broken chunk back in?? Or should i start looking for a casking from a wrecker.
Tractor is a 1994 MF 3670 (160hp) with approx 5500 hrs on the clock. It is my main tractor, does all the hard work.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.