Posted by JDseller on July 10, 2011 at 21:46:27 from (208.126.196.144):
Have any of you had problems with the gate latch hooks/arms on JD round balers(535,566,567,567) lately??? They all use the same latch. I have had to replace five of them on three different bales this haying season. They all where bent. Usually they only get bent if the baler makes an over size bale. I even bent one on my 567. I know I never over sized the baler. I usually only make 66 inch bales. I am wondering if there is a bad batch of soft ones out there. The one I bent on my baler was a new one. I had robbed one to get a neighbor going over a weekend. The orginal was fine the new one was bent. The latch angle is off and then the door will open when you get to 3/4s of a bale.
How about it TXJIM it seems you do a bunch of baling, have you seen any problems???
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Diagnosing Engine Difficulty - Diesel Tractors - by Staff. The following suggestions are listed for your assistance. You can make simple adjustments on your tractor that will improve its operation and save you the time and expense of hiring someone to do it for you. Always make one adjustment at a time, and if the adjustment made does not improve the condition, return to the original setting before proceeding to the next adjustment. Hard Starting Cold air temperatures. Insufficient fuel.
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.